Canon EOS-1D Mark II Digial Manual de instrucciones - Página 15

Navegue en línea o descargue pdf Manual de instrucciones para Software Canon EOS-1D Mark II Digial. Canon EOS-1D Mark II Digial 19 páginas. Firmware update procedures
También para Canon EOS-1D Mark II Digial: Folleto y especificaciones (20 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones (41 páginas), Manual de software (2 páginas), Manual de software (2 páginas), Consejos y técnicas (35 páginas), Manual del producto (39 páginas), Manual de bolsillo (2 páginas), Manual del usuario (2 páginas), Especificaciones (2 páginas), Libro Manual (29 páginas), Manual rápido (2 páginas), Manual de consulta rápida (2 páginas), Manual de actualización (8 páginas)

Imprimir página
Canon EOS-1D Mark II Digial Manual de instrucciones

Color Display Mode

You can select the color display mode which will be the basis for color
adjustment from three options (HSL, Lab or RGB) as well as check
values for adjusted colors.
Color value after adjustment
Color value before adjustment
When "HSL" is selected for the color display mode, you can only
change the color value for before adjustment by entering a
number.
HSL is a color mode expressed by the three elements of hue (H),
saturation (S) and luminosity (L).
Lab is a color mode developed by the CIE (Commission
Internationale d'Eclairage) where L displays lightness, a displays
color elements from green to magenta and b displays color
elements from blue to yellow.
RGB is a color mode which expresses red (R), green (G) and
blue (B), the three primary colors (additive colors) of the visible
light spectrum.
Switches the color display
mode

Adjusting Brightness and Contrast (Gamma Characteristic)

You can adjust the brightness and contrast of a specific area using the
tone curve.
Adjust the brightness and contrast.
The brightness and contrast of the image change.
The horizontal axis shows the input level and the vertical axis
shows the output level.
The maximum number of [
To delete a [
], select the [
key on the keyboard or double-click on the [
Click to add a [
]
(adjustment point) and
adjust by dragging
The setting value of the
selected point (you can
also enter numerical
values)
] is 10.
] and then either press the <Del>
].
Introduction

Contents

Preparing

a Sample
Basic
Windows
Pre-adjustments
Image
Characteristics
Saving
Preferences
Reference
14