Bolton Tools HP-L4G Manual de instalación, uso y mantenimiento - Página 9

Navegue en línea o descargue pdf Manual de instalación, uso y mantenimiento para Sistemas de elevación Bolton Tools HP-L4G. Bolton Tools HP-L4G 16 páginas. Two-post model autolift

Imprimir página

should be taken to keep dirt or other contamination out of oil.

RM INSTALLATION

Lubricate the arm pin or carriage arm pin hole with "anti-seize" and install the arms. Insure that the

22.

arm restraint gears engage and disengage properly. Arm restraints any binding occurs, insure that the

large gear mounted to the arm has been factory installed tight against the arm pin.

INAL ADJUSTMENTS

Lower the lift to the floor and raise the lift approximately one foot.

23.

Start with Idler side first. Slowly and carefully loosen the bleed plug on top of the cylinder just

24.

enough to allow the entrapped air to escape. Repeat for power side.

Energize the power unit and raise 6 inches. Repeat previous step until no air comes out of cylinder.

25.

Pressure test hydraulic system. Energize power unit, raise lift to full rise and continue to run motor

26.

for additional 10 seconds. (NOTE: pressure relief will make a high pitch squeal sound for these 10

seconds.) Check hydraulic system for leaks.

Energize power unit again for 10 seconds. With a clean rag, wipe down both cylinder rods. If

27.

lubricant is not wiped clean from the cylinder rod, the cylinder will appear to be leaking.

Cycle lift to insure that the latches operate simultaneously. Lower the lift onto the locks and insure

28.

that neither lock will wobble (it is possible for the carriages to appear to be resting on the locks

when actually only one carriage is resting on its lock and the other carriage is being supported by the

synchronizing cable).

Lower lift to the floor. Pull and release lock release handle while watching idler column lock. Adjust

29.

threaded sleeve cable adjuster nuts until idler column lock disengages and engages fully. When

properly adjusted, the idler column lock should just come to rest against the back of the column

when engaged and fully out against the tab when disengaged.

IMPORTANT

: IF IDLER SIDE LOCK PAWL DOES NOT FULLY DISENGAGE, DAMAGE

MAY RESULT TO IDLER SIDE CARRIAGE AND OR CABLE SYNCHRONIZING SYSTEM.

Tighten and trim wire ties.

30.

Snap lock cover over each lock assembly.

31.

PERATION PROCEDURE

AFETY NOTICES AND DECALS

This product is furnished with graphic safety warning labels, which are reproduced on page 3 of

these instructions. Do not remove or deface these warning labels, or allow them to be removed or

defaced. For your safety, and the safety of others, read and understand all of the safety notices and

decals included.

WNER/EMPLOYER RESPONSIBILITIES

The Owner/Employer shall insure that lift operators are qualified and that they are trained in the safe

use and operation of the lift using the manufacturer's operating instructions;, Lifting it Right safety

manual; American National Standard for Automotive Lifts-Safety Requirements for Operation,

Inspection and Maintenance; ALI Uniform Warning Label Decals/Placards; and in case of frame

engaging lifts, Vehicle Lifting Points/Quick Reference Guide for Frame Engaging Lifts.