Bolton Tools HP-L4G Manual de instalación, uso y mantenimiento - Página 8

Navegue en línea o descargue pdf Manual de instalación, uso y mantenimiento para Sistemas de elevación Bolton Tools HP-L4G. Bolton Tools HP-L4G 16 páginas. Two-post model autolift

Imprimir página

Prior to operation of lift recheck equalizer cables making sure they are not

crossed or routed improperly. Be sure the cables have remained in place

over the pulleys.

OWER UNIT &

Mount Power Unit to power column as shown in Fig 6 The mounting hardware, M8 hex nuts, are pre-

18.

installed on power unit mounting bracket.

IMPORTANT – To insure proper hose fitting seal without damage to the fitting follow this

19.

procedure for each hose connection: Screw flared fitting on finger tight. Rotate flared fitting 1 1/2 hex

flats (90 deg.). Back the flared fitting off one full turn. Again tighten flared fitting finger tight, then

rotate flared fitting 1 1/2 hex flats (90 deg).

Thread power unit hydraulic hose into elbow on power unit. Route hydraulic hose from Idler column

20.

across floor plate ass'y to the Power Column.(Fig 6)

Once the Power Unit is secured, fill reservoir with #10 weight HYDRAULIC OIL ONLY. Care

21.

Fig 4- Cable Routing

Fig 5- Attaching Cable

YDRAULIC HOSE