Dafra DRPB48V Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Herramientas Dafra DRPB48V. Dafra DRPB48V 13 páginas.

DRPB48V Operation Manual

SETTING UP THE TOOL

Please refer to the TOOL EXPLOSIVE ILLUSTRATION and the PARTS LIST included in this

manual in order to have a good understanding of the tool parts described. The descriptions of

the tool parts appear in this manual in italics with the parts position numbers corresponding to

the tool explosive illustration.

1) This pneumatic powered tool should be used with compressed air supply. It is recommended

to use the air hose with diameter bigger than 8 mm.

2) Check that the compressed air pressure is within the specified range between 0.5Mpa and

0.7Mpa, before connecting the air hose onto the tool air adaptor (#52). The air adaptor has

different versions in different countries and areas. Normally the tools are equipped with the

correct version, however if the air adaptor supplied does not match your air supply hose,

contact the tool distributor(s).

3) Change and use correct nosepiece (#1) according to the size of the rivet to be set. This tool

is equipped with nosepieces 3.0mm/3.2mm, 4.0mm and 4.8mm/5.0mm (on the tool) in the

kit. Follow the steps below to change the nosepiece (#1):

a) Remove the air supply hose from air adaptor (#52);

b) Use the wrench (in accessories pack) to remove the nosepiece (#1) from the tool:

a) Select the correct nosepiece in accessories pack and screw on to the tool, using the

wrench to fix it firmly on the tool.

4) To install the mandrel collector (#24, in accessories pack) on the back of the tool.