Dotco 14CFS93-98 Manual de piezas - Página 3
Navegue en línea o descargue pdf Manual de piezas para Herramienta eléctrica Dotco 14CFS93-98. Dotco 14CFS93-98 8 páginas. 14cf series, shears & scissors
Imprimir páginaDISASSEMBLY
1. Loosen (3) cap screws. Remove shear head by twisting
and pulling forward.
2. Remove the (3) cap screws completely. Be careful not to
lose rear bushing when removing middle cap screw.
3. Remove center scissor blade from shear housing by
tapping blade gently rearward. Be careful not to lose
bushing from hole in center blade. Side knife and side
spacer will now drop out of housing.
ASSEMBLY
1. Install spacer (part #1546) over planet cage, then
eccentric bearing assembly. Tighten bearing assembly.
Lubricate bearing with a good grade of bearing
grease.
Installing cutter blades:
2. Place the side knife and side spacer in position in the
shear housing. Insert center cap screw with rear spacer
14CFS93-98 Scissors & 14CFS93-99 Shears
DOTCO
bushing (part #14-1556) between them - start cap screw
into threads just enough to hold blades in position. DO
NOT TIGHTEN.
3. Insert spacer bushing into hole in center scissor blade and
lubricate with a good grade of bearing grease.
4. Install center scissor blade into shear housing by tapping
blade gently forward, using a drift to line up hole in center
blade with forward holes in housing.
5. Insert and tighten forward cap screw, making sure spacer
bushing in center blade stays in position.
6. Apply a good grade of bearing grease to yoke of center
blade where it rides on the eccentric bearing assembly.
7. Insert rear cap screw but do not tighten.
Installing shear head assembly on tool:
8. Loosen all three cap screws about three or four turns.
9. Place shear head onto tool and tighten screws snugly.
Page 3
PL31-14CF-1
September 11, 2002