Dotco 14CFS93-98 Parts Manual - Page 3

Browse online or download pdf Parts Manual for Power Tool Dotco 14CFS93-98. Dotco 14CFS93-98 8 pages. 14cf series, shears & scissors

Print Page

DISASSEMBLY

1. Loosen (3) cap screws. Remove shear head by twisting

and pulling forward.

2. Remove the (3) cap screws completely. Be careful not to

lose rear bushing when removing middle cap screw.

3. Remove center scissor blade from shear housing by

tapping blade gently rearward. Be careful not to lose

bushing from hole in center blade. Side knife and side

spacer will now drop out of housing.

ASSEMBLY

1. Install spacer (part #1546) over planet cage, then

eccentric bearing assembly. Tighten bearing assembly.

Lubricate bearing with a good grade of bearing

grease.

Installing cutter blades:

2. Place the side knife and side spacer in position in the

shear housing. Insert center cap screw with rear spacer

14CFS93-98 Scissors & 14CFS93-99 Shears

DOTCO

bushing (part #14-1556) between them - start cap screw

into threads just enough to hold blades in position. DO

NOT TIGHTEN.

3. Insert spacer bushing into hole in center scissor blade and

lubricate with a good grade of bearing grease.

4. Install center scissor blade into shear housing by tapping

blade gently forward, using a drift to line up hole in center

blade with forward holes in housing.

5. Insert and tighten forward cap screw, making sure spacer

bushing in center blade stays in position.

6. Apply a good grade of bearing grease to yoke of center

blade where it rides on the eccentric bearing assembly.

7. Insert rear cap screw but do not tighten.

Installing shear head assembly on tool:

8. Loosen all three cap screws about three or four turns.

9. Place shear head onto tool and tighten screws snugly.

Page 3

PL31-14CF-1

September 11, 2002