Douglas Dynamics Fisher Minute Mount 2 XLS 50810 Manual de instrucciones de instalación - Página 5

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Accesorios para automóviles Douglas Dynamics Fisher Minute Mount 2 XLS 50810. Douglas Dynamics Fisher Minute Mount 2 XLS 50810 17 páginas. Snowplow

Imprimir página

BLADE, A-FRAME AND HEADGEAR

1. Remove the headlamp box and small parts box

from the carton. Remove the carton wall sleeve by

sliding it up and over the box contents. Remove

and discard the four corner tubes and place the

sleeve ﬂ at on the ﬂ oor. Remove the headgear and

power unit assembly from the box and place it on

the carton sleeve. Remove the A-frame and place

it on the carton sleeve.

2. Place some cardboard or wood on the ﬂ oor where

the blade will be assembled. Remove the blade

from the pallet and place it face down. Position the

A-frame assembly so that the holes in the A-frame

are aligned with the holes in the blade. Insert the

pivot bolt (from top to bottom) through all holes.

Secure with a 1" locknut and tighten.

Pivot Bolt

3. Cut the tie holding the angle rams to the A-frame.

Remove the protective caps on the angle rams.

Swing the A-frame to one side so that the holes

in the rod end of the angle ram and the blade are

aligned.

Lit. No. 50579, Rev. 02

4. Install a 1" x 4-3/4" clevis pin from the top down.

Swing the A-frame to the other side and secure

the second angle ram in the same manner. Secure

the angle rams by installing 1/4" x 1-1/2" cotter

pins in the two rod-end clevis pins.

Cotter Pin

5. Remove the 1" x 4" clevis pin from the base end

of one of the angle rams and install the ﬁ tting as

shown.

Locknut

20°

DS Angle Ram

Reattach the base end of the angle ram with a

1" x 4" clevis pin and secure with a 1-1/2" cotter

pin. Repeat this process for the second angle ram.

For blades built after March 2, 2010, these ﬁ ttings

are pre-installed and the cylinders are pre-ﬁ lled

with hydraulic ﬂ uid. The build date can be found

in the ﬁ rst six digits of the serial number, located

in the upper right corner on the back of the blade

(YYMMDD: YY = 2-digit year, MM = 2-digit month,

DD = 2-digit day).

50600, 50810

Clevis Pin

20°

90°

Elbow

PS Angle Ram

April 15, 2010

90°

Elbow