Amphenol Temposonics MH Series Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Accesorios Amphenol Temposonics MH Series. Amphenol Temposonics MH Series 18 páginas. Analogue/pwm tester
También para Amphenol Temposonics MH Series: Manual del usuario (12 páginas)
Imprimir página
Temposonics
MH Analog
®
Operating Manual
4. Electrical connection
Temposonics
MH series sensors are equipped with an M12 connector. For electrical wiring pin assignment has to be checked. Optionally, the
®
sensors are available with single wire or PUR cable outlet. Please use suitable mating connectors.
Detailed information relating to the mechanical installation of the sensor in the mobile hydraulic cylinder is given
in the installation instructions. During installation, make sure that cables are located correctly inside the cylinder.
The cables must not be squeezed and should be laid without mechanical stress.
Protection types
To connect the sensor under harsh environmental conditions, ideally a PUR cable with an integral connector and a stainless steel lock nut
should be used. For connection according to protection types IP68 and IP69K, a corresponding tested mating plug is required.
4.1 Connecting diagrams, pin allocation, conductor colors
Type MH Analog
Connector system M12
4 x 0,25 mm
2
Pin assignment connector system M12
E
12/24 VDC
2
GND (OV)
3
Signal
4
n.c.
1
Single wires
3 x 0,5 mm
2
Wire assignment single wires
12/24 VDC
GND (OV)
Signal
PUR cable:
3 x 0,5 mm
2
Wire assignment PUR-cable
12/24 VDC
GND (OV)
Signal
4
G
H
1
1
3
3
4
2
1
2
4
Top view:
male pin connector
Wire color
BN
WH
GN
Wire color
BN
WH
GN
3
2
I
6
I