- ページ 6
アクセサリー Amphenol Temposonics MH SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Amphenol Temposonics MH Series 18 ページ。 Analogue/pwm tester
Amphenol Temposonics MH Series にも： ユーザーマニュアル (12 ページ)
ページを印刷する
Temposonics
MH Analog
®
Operating Manual
4. Electrical connection
Temposonics
MH series sensors are equipped with an M12 connector. For electrical wiring pin assignment has to be checked. Optionally, the
®
sensors are available with single wire or PUR cable outlet. Please use suitable mating connectors.
Detailed information relating to the mechanical installation of the sensor in the mobile hydraulic cylinder is given
in the installation instructions. During installation, make sure that cables are located correctly inside the cylinder.
The cables must not be squeezed and should be laid without mechanical stress.
Protection types
To connect the sensor under harsh environmental conditions, ideally a PUR cable with an integral connector and a stainless steel lock nut
should be used. For connection according to protection types IP68 and IP69K, a corresponding tested mating plug is required.
4.1 Connecting diagrams, pin allocation, conductor colors
Type MH Analog
Connector system M12
4 x 0,25 mm
2
Pin assignment connector system M12
E
12/24 VDC
2
GND (OV)
3
Signal
4
n.c.
1
Single wires
3 x 0,5 mm
2
Wire assignment single wires
12/24 VDC
GND (OV)
Signal
PUR cable:
3 x 0,5 mm
2
Wire assignment PUR-cable
12/24 VDC
GND (OV)
Signal
4
G
H
1
1
3
3
4
2
1
2
4
Top view:
male pin connector
Wire color
BN
WH
GN
Wire color
BN
WH
GN
3
2
I
6
I