AMPHIBICO genesis fs-700 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Accesorios para cámaras AMPHIBICO genesis fs-700. AMPHIBICO genesis fs-700 17 páginas. For the sony nex fs-700

Imprimir página

PREPARING CAMCORDER & HOUSING

INSTALLING ACCESSORIES

The GENESIS FS-700 housing is been equipped with a large amount of mounting points and an optional railing

system is available to accommodate a variety of accessories. Some of the mounting point locations have been

designated to specific positions for your convenience. However, these locations could and can be used for other

accessories. Theses mounting points will allow the addition of external monitor and video lighting to be attached

to the housing. Accessory passthrough connector ports (up to six ) are provided in both 1/2'' and 16mm size for

installing external monitor.

Achieving neutral buoyancy and balance

The Dome port and lens configuration, and adding accessories to the housing, may offset the trim of the housing

underwater. Whether in fresh or salt water, the GENESIS can be perfectly balanced and neutral in buoyancy by

adding and properly locating the optional trim weights on the side mounted rail (#20 & 21)

WATER ENTRY

1. Always turn housing to its ON position before entering water. To turn it ON, use the right grip trigger button. This

is confirmed by the CAM. Indicator light turning on a steady green. The camcorder top LCD viewfinder will also

turn ON. Doing step 1 will activate the built-in moisture alarm sensor located in the bottom of the housing.

IMPORTANT

The lights located on the right on both grips will start flashing RED if water leakage occurs inside the housing.

Should this happen, proceed to the surface in a safe manners, remove the housing from water as soon as possi-

ble, take the camcorder out of the housing and inspect all seals and the inside of the housing. ALWAYS REMEM-

BER YOUR PERSONNAL AND OTHER SAFETY FIRST.

2. Lower the housing just below the water surface in level position and hold for one minute to confirm there is no

leakage in the housing. Never leap into the water while holding the housing. Always have the housing handed to

you or lowered down once you are in the water.

3. Point the lens of the housing upwards and shake off any residual air bubbles by fanning your hand in front of

the port. If necessary, gently wipe the lens with your finger to remove left over bubbles.

Page 7