Caraudio-Systems c.LOGiC C2-CIC Manual - Página 10
Navegue en línea o descargue pdf Manual para Electrónica del automóvil Caraudio-Systems c.LOGiC C2-CIC. Caraudio-Systems c.LOGiC C2-CIC 13 páginas. For bmw professional navigation systems with idrive and 6.5”/8.8” monitor
Imprimir página3.4.2. Installing AV-source's IR-sensor additionally
Additionally to the control via OEM navigation, it is possible to install the original IR-sensor
of a connected device. By using the respective Y-adapter (e.g. STA-Y35MM or STA-RJ12) for
the IR-Port of the connected device, the controls of navigation AND device's IR-sensor can be
connected and used simultaneously. Installation of the IR-sensor is recommended as the
controls via navigation are limited, and not all functions may be covered.
3.4.3. After-market rear-view camera and rear-seat-entertainment
Using RCA-cables, connect the rear-seat-entertainment to the female RCA-connector
VIDEO OUT of MOST®-box C2C-M336.
Note: As the output is a full output, not shared with the video signal for the
navigation system, splitting the video with an RCA Y-cable might give a good enough
picture for two rear-seat-entertainment monitors. If not, or if connecting more than
two monitors, use a video splitter.
Connect the video RCA of the after-market rear-view camera to the
the female RCA connector R-CAM IN of MOST®-box C2C-M336.
Cut the green wire of harness C3C-BMW0x about 10cm
from its 14pin Molex connector. The end connected to the
14pin Molex connector can be used as +12V power (max 1A)
supply for the rear-view camera. Isolate the other end.
Note: Automatic switching to after-market rear-view camera works
only from interface mode.
Version 22.03.2011
14pin Molex connector
of harness C3C-BMW0x
C2-CCC/C2-CIC