DPW Design Expander E-1 Manual - Página 5

Navegue en línea o descargue pdf Manual para Sintetizador DPW Design Expander E-1. DPW Design Expander E-1 6 páginas.

All steps describes so far with oscilloscope pictures has been with OffP and OffN in the same

position just to explain how you build your waves.

Adding CV to P and N gives the possibility to morph your waves.

The two waves shown above are a simple example of one wave being morphed in to an other with

control voltages in on P and N.

Try different waves in, LFOs or audio signals to P and N as well sa LFOs or audio signals to Lin

and Dist on the E-1 expander and you can get very complex interesting shapes out.

Don't forget to try it with control signals. Messing up an envelope signal that controls a filter for

instance can be very interesting. Or using the FoP or FoN to trigger something at different levels of

the envelope signal.

DPW Design, Häradsvägen 200, 14171 Segeltorp, Sweden

www.dpw.se

If you then turn FoP anticlockwise you can subtract

the FoP signal from the wave when the positive folder

is active.

Turning Mod down to center position makes the wave

be horizontal during the time the folders are active.

Turning the Mod completely off will restore the shape

of the tips of the incoming triangle wave. So this is just

a triangle wave with parts of it offset by FoP and FoN.

Turning the Clean off will leave a stepped square

wave produced be FoP + FoN.

If you want it in phase with the triangle wave on IN you

simply turn FoP and FoN to the other side of the center

position.

Or you do this by adjusting FoP and FoN.

MAN-WF-1 Rev B