DPW Design Expander E-1 Manual - Page 5
Browse online or download pdf Manual for Synthesizer DPW Design Expander E-1. DPW Design Expander E-1 6 pages.
Print PageAll steps describes so far with oscilloscope pictures has been with OffP and OffN in the same
position just to explain how you build your waves.
Adding CV to P and N gives the possibility to morph your waves.
The two waves shown above are a simple example of one wave being morphed in to an other with
control voltages in on P and N.
Try different waves in, LFOs or audio signals to P and N as well sa LFOs or audio signals to Lin
and Dist on the E-1 expander and you can get very complex interesting shapes out.
Don't forget to try it with control signals. Messing up an envelope signal that controls a filter for
instance can be very interesting. Or using the FoP or FoN to trigger something at different levels of
the envelope signal.
DPW Design, Häradsvägen 200, 14171 Segeltorp, Sweden
www.dpw.se
If you then turn FoP anticlockwise you can subtract
the FoP signal from the wave when the positive folder
is active.
Turning Mod down to center position makes the wave
be horizontal during the time the folders are active.
Turning the Mod completely off will restore the shape
of the tips of the incoming triangle wave. So this is just
a triangle wave with parts of it offset by FoP and FoN.
Turning the Clean off will leave a stepped square
wave produced be FoP + FoN.
If you want it in phase with the triangle wave on IN you
simply turn FoP and FoN to the other side of the center
position.
Or you do this by adjusting FoP and FoN.
MAN-WF-1 Rev B