Comelit Icona 6601W/BM Manual técnico - Página 15

Navegue en línea o descargue pdf Manual técnico para Monitor Comelit Icona 6601W/BM. Comelit Icona 6601W/BM 17 páginas. 2-wire door entry monitor
También para Comelit Icona 6601W/BM: Manual técnico (20 páginas), Manual del usuario (7 páginas), Manual del usuario (18 páginas)

Imprimir página
Comelit Icona 6601W/BM Manual técnico

LED/alarm/lock-release/actuator programming

Take note of the S2, S1 settings and restore on completion of programming
Input IN 1- IN 2
LED (default)*
Input CFP2 - IN 1
ALARM*
Input CFP2 - IN 1
LOCK-RELEASE*
Input CFP2 - IN 1
CODED
ACTUATOR*
Input CFP2 - IN 1
GENERIC ACTUATOR*
* See
"Connections" on page
When the procedure is complete, restore the initial DIP-switch combination.

Changing the ringtone

1. Press and hold
for 6 sec.
»
a confirmation tone is emitted
»
the LED
flashes
√ the procedure can only take place while the system is in standby; otherwise the LED
user that the system is busy
2. Press and release
Once (1 confirmation tone is emitted) to change the ringtone for calls from the external entrance panel.
twice (2 confirmation tones are emitted) to change the ringtone for calls from the switchboard.
3 times (3 confirmation tones are emitted) to change the ringtone for intercom calls made from the door entry monitor.
4 times (4 confirmation tones are emitted) to change the floor door call ringtone.
Any further pressing of the button repeats the sequence described above.
3. Press and release to scroll through the available ringtones in sequence.
4. Press the
buttonto confirm selection of the last ringtone heard and to exit change door entry monitor ringtone mode.
»
a confirmation tone is emitted
»
LED
switches off
1.
2.
S2
S2
S1
set code,
"Addressing
table" on page
17
S1
8.
3.
OK prog:
S2
x4
KO prog:
x10
will flash 4 times to inform the
4.
15