Comelit Icona 6601W/BM 기술 매뉴얼 - 페이지 15
{카테고리_이름} Comelit Icona 6601W/BM에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Comelit Icona 6601W/BM 17 페이지. 2-wire door entry monitor
Comelit Icona 6601W/BM에 대해서도 마찬가지입니다: 기술 매뉴얼 (20 페이지), 사용자 설명서 (7 페이지), 사용자 설명서 (18 페이지)
페이지 인쇄
LED/alarm/lock-release/actuator programming
Take note of the S2, S1 settings and restore on completion of programming
Input IN 1- IN 2
LED (default)*
Input CFP2 - IN 1
ALARM*
Input CFP2 - IN 1
LOCK-RELEASE*
Input CFP2 - IN 1
CODED
ACTUATOR*
Input CFP2 - IN 1
GENERIC ACTUATOR*
* See
"Connections" on page
When the procedure is complete, restore the initial DIP-switch combination.
Changing the ringtone
1. Press and hold
for 6 sec.
»
a confirmation tone is emitted
»
the LED
flashes
√ the procedure can only take place while the system is in standby; otherwise the LED
user that the system is busy
2. Press and release
Once (1 confirmation tone is emitted) to change the ringtone for calls from the external entrance panel.
twice (2 confirmation tones are emitted) to change the ringtone for calls from the switchboard.
3 times (3 confirmation tones are emitted) to change the ringtone for intercom calls made from the door entry monitor.
4 times (4 confirmation tones are emitted) to change the floor door call ringtone.
Any further pressing of the button repeats the sequence described above.
3. Press and release to scroll through the available ringtones in sequence.
4. Press the
buttonto confirm selection of the last ringtone heard and to exit change door entry monitor ringtone mode.
»
a confirmation tone is emitted
»
LED
switches off
1.
2.
S2
S2
S1
set code,
"Addressing
table" on page
17
S1
8.
3.
OK prog:
S2
x4
KO prog:
x10
will flash 4 times to inform the
4.
15