Bosch 800 Series Manual de instalación - Página 22

Imprimir página

Replacing the Broil Burner Nozzle

Open the appliance door.

Remove the screws on the broil burner sub assembly

and pull the broil sub assembly forwards out of the

gas connection. On the back wall, the burner is still

connected to the gas supply and the electric ignition.

Carefully place the broil assembly on the floor of the

oven cavity.

Unscrew the broil burner nozzle and replace it with the

LP nozzle number 110.

Reinsert the broil burner & broil burner sub assembly

and screw tight.

Fill out the LP conversion label (included) and affix to

the appliance.

Setting the minimum gas flow

Open the appliance door.

Press and hold the control knob for the oven and turn

it to the maximum position. The gas burner ignites.

Keep the control knob pressed in for 15 seconds.

Close the appliance door.

Remove the control knob and knob ring.

Tighten the inner setting screw.

Note: In case of conversion from propane gas to

natural gas, turn out all bypass nozzles for 1/2 turn.

Refit the control knob.

Heat up the oven for 15 minutes.

Remove the control knob again.

Adjust the internal setting screw until a stable flame is

10.

burning correctly. Loosen the setting screw to increase

the gas flow or tighten it to decrease the gas flow. The

setting is correct when the height of the small flame is

approx. 1/8" (3 to 4 mm).

Refit the control knob and knob ring.

11.

Ensure that the flame does not go out when the gas

12.

flow is quickly changed between maximum and

minimum, and vice versa.

Checking functions after the conversion:

The flames must not go out when switching over swiftly

from the high to the low setting.

Note: Stick the adhesive label included with the nozzle

set over the rating plate of the appliance to document the

changeover to a different gas type.

Test for Gas Leaks

After the conversion it is important to verify the leakages.

~ Page 17