Electrolux # Manual de uso y mantenimiento - Página 18

Navegue en línea o descargue pdf Manual de uso y mantenimiento para Horno Electrolux #. Electrolux # 20 páginas. Gas cooktop
También para Electrolux #: Manual de instrucciones de instalación (8 páginas), Recetario (17 páginas), Manual de instrucciones (12 páginas), Manual de uso y mantenimiento (20 páginas), Libro de instrucciones (16 páginas), Libro de instrucciones (12 páginas), Manual de inducción (16 páginas), Manual del usuario (11 páginas), Manual del usuario (9 páginas), Manual de uso y mantenimiento (16 páginas), Manual de uso y mantenimiento (16 páginas), Manual del usuario (16 páginas), Manual de uso y mantenimiento (16 páginas)

Imprimir página
Electrolux # Manual de uso y mantenimiento
Solutions to Common Problems
SURFACE BURNERS DO NOT UGHT
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
e
e
Surface Control knob has not been completely turned to LITE. Push in and turn the
Surface Control knob to LITE until burner ignites and then turn control knob to desired
flame size.
Be sure gas supply valve is open.
Burner ports are clogged. Clean burners. See Cleaning
the Burner Grates, Burner
Caps,Burner
Heads in General Care & Cleaning section. With the burner off, clean
ports with a small-gauge wire or needle.
Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord is
securely plugged into the outlet.
Electrical power outage (electric ignition models only). Burners can be lit manually. See
Setting Surface Controls
in this Use and Care Guide.
BURNER FLAME ONLY LIGHTSHALF WAY AROUND
BURNER
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire
or needle.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until
flame is full. Dry the burners thoroughly following instructions in the General Cleaning
section.
BURNERFLAMEIS ORANGE
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
•
Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
•
In coastal areas, a slightly orange flame is unavoidable due to salt air.
[]