Electrolux # Посібник з використання та догляду - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник з використання та догляду для Духовка. Electrolux #. Electrolux # 20 сторінок. Gas cooktop
Також для Electrolux #: Інструкція з монтажу Посібник з монтажу (8 сторінок), Книга рецептів (17 сторінок), Інструкція з експлуатації (12 сторінок), Посібник з використання та догляду (20 сторінок), Інструкція з експлуатації (16 сторінок), Інструкція з експлуатації (12 сторінок), Посібник із введення в курс справи (16 сторінок), Посібник користувача (11 сторінок), Посібник користувача (9 сторінок), Інструкція з використання та догляду (16 сторінок), Інструкція з використання та догляду (16 сторінок), Посібник користувача (16 сторінок), Інструкція з використання та догляду (16 сторінок)

Electrolux # Посібник з використання та догляду
Solutions to Common Problems
SURFACE BURNERS DO NOT UGHT
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
e
e
Surface Control knob has not been completely turned to LITE. Push in and turn the
Surface Control knob to LITE until burner ignites and then turn control knob to desired
flame size.
Be sure gas supply valve is open.
Burner ports are clogged. Clean burners. See Cleaning
the Burner Grates, Burner
Caps,Burner
Heads in General Care & Cleaning section. With the burner off, clean
ports with a small-gauge wire or needle.
Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord is
securely plugged into the outlet.
Electrical power outage (electric ignition models only). Burners can be lit manually. See
Setting Surface Controls
in this Use and Care Guide.
BURNER FLAME ONLY LIGHTSHALF WAY AROUND
BURNER
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire
or needle.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate until
flame is full. Dry the burners thoroughly following instructions in the General Cleaning
section.
BURNERFLAMEIS ORANGE
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
In coastal areas, a slightly orange flame is unavoidable due to salt air.
[]