Bosch FAP-OC 500Series Información sobre el producto - Página 12

Product Information 500 Series LSN Fire Detectors (EU)

3. Programming

LSN detectors are programmed according to the required operating mode.

Programming is carried out with the programming software using a PC or laptop con-

nected to the fire panel.

The suitable response sensitivity of the multisensor detector is programmed by speci-

fying the operating location (e.g. computer room, office, large kitchen). The selection of

the operation location determines the optimal characteristic diagram for the fire and dis-

turbance variable evaluation.

If, according to the operating location, a low sensitivity is set for the optical sensor, the

alarm goes off only if the detector senses high levels of smoke and of CO at the same

time. This is the case with open or smouldering fire.

Programming the multisensor detector and linking all detectors by algorithms, consider-

ably increases the fire detection reliability and lowers the false alarm rate.

FAP−OC 500(−P)

Operating locations for multisensor detector

(FAP−OC 500) selectable via the programming software

Office (smokers) / waiting room / restaurant / conference

room

Conference room / waiting room / exhibition hall

Warehouse with vehicle traffic

Production facilities

Kitchen / casino / restaurant during operation

Garage

Office (daily operation)

School / kindergarten

Theaters / concert halls

Office (no traffic)

Computer room

High−board warehouse without vehicle traffic with internal

combustion engines

Page 12

PI − 34.70 en

Sensitivity

O unit

C unit

low

medium

high

BDL−F.01U.025.876

A5.en/ 02.02.2006

ST−FIR/PRM1 / zab