Draper FlexShade Instrucciones de instalación y funcionamiento - Página 3

Navegue en línea o descargue pdf Instrucciones de instalación y funcionamiento para Pantalla de proyección Draper FlexShade. Draper FlexShade 16 páginas. Exterior clutch-operated shade
También para Draper FlexShade: Manual de instalación y funcionamiento (8 páginas), Instrucciones de instalación (2 páginas), Manual de instrucciones (12 páginas), Instrucciones de instalación y funcionamiento (11 páginas), Instrucciones de instalación y funcionamiento (12 páginas), Instrucciones de instalación y funcionamiento (4 páginas), Manual de instrucciones (7 páginas), Instrucciones de instalación y funcionamiento (12 páginas), Instrucciones de instalación y funcionamiento (16 páginas)

Imprimir página

Draper FlexShade Instrucciones de instalación y funcionamiento

Exterior Motorized FlexShade

Section 1 - Preparation for Installation

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.

Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.

MOUNTING

1 "

BRACKET

(44 mm)

E N

D C

A P

Figure 1

Section 2 - Mounting Headbox with Brackets

Caution: Mounting Brackets

required for proper spacing of unit

off the wall for Side Channel

alignment.

Figure 3

1. Ensure mounting surface is strong enough to hold the Exterior Motorized FlexShade

2. Verify unit measurements and make sure it will fit in the desired location.

Please Note: Hem Bar does not retract into

the Headbox and must be accounted for if

mounting over a swinging window or door.

3. Mounting Brackets MUST be installed with a

gap of 1 3/4"

between the Endcap and

(44mm)

the Mounting Bracket edge

or jamb.

4. Drill small starter holes

(if necessary)

mounting surface.

5. Determine which headbox style is being

used

(Fig. 2)

1. Attach Mounting Brackets to the wall using #10 flat

head screws installed flush with bracket.

Please Note: Be sure to use AT LEAST 2 of the top

mounting holes.

3 "

. Mark wall

(Fig. 1)

Square

Headbox

Tighten Set Screws

page 3 of 16

Figure 2

HEADBOX STYLES

3 "

(92mm)

3 "

(92mm)

2. Attach Headbox to brackets and tighten

Set Screws.

3. Mount the Side Channels

(92mm)

Cur

Hea

(Section 4)