Draper FlexShade Instructions Installation et fonctionnement - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions Installation et fonctionnement pour {nom_de_la_catégorie} Draper FlexShade. Draper FlexShade 16 pages. Exterior clutch-operated shade
Également pour Draper FlexShade : Manuel d'installation et d'utilisation (8 pages), Instructions d'installation (2 pages), Manuel d'instructions (12 pages), Instructions d'installation et d'utilisation (11 pages), Instructions Installation et fonctionnement (12 pages), Instructions Installation et fonctionnement (4 pages), Manuel d'instructions (7 pages), Instructions Installation et fonctionnement (12 pages), Instructions Installation et fonctionnement (16 pages)

Imprimer la page
Draper FlexShade Instructions Installation et fonctionnement
Exterior Motorized FlexShade

Section 1 - Preparation for Installation

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
MOUNTING
1 "
BRACKET
(44 mm)
E N
D C
A P
Figure 1

Section 2 - Mounting Headbox with Brackets

Caution: Mounting Brackets
required for proper spacing of unit
off the wall for Side Channel
alignment.
1
Figure 3
3
1. Ensure mounting surface is strong enough to hold the Exterior Motorized FlexShade
2. Verify unit measurements and make sure it will fit in the desired location.
Please Note: Hem Bar does not retract into
the Headbox and must be accounted for if
mounting over a swinging window or door.
3. Mounting Brackets MUST be installed with a
gap of 1 3/4"
between the Endcap and
(44mm)
the Mounting Bracket edge
or jamb.
4. Drill small starter holes
(if necessary)
mounting surface.
5. Determine which headbox style is being
used
.
(Fig. 2)
1. Attach Mounting Brackets to the wall using #10 flat
head screws installed flush with bracket.
Please Note: Be sure to use AT LEAST 2 of the top
mounting holes.
®
3 "
. Mark wall
(Fig. 1)
Square
Headbox
in
2
4
Tighten Set Screws
page 3 of 16
.
®
Figure 2
HEADBOX STYLES
3 "
(92mm)
3 "
(92mm)
2. Attach Headbox to brackets and tighten
Set Screws.
3. Mount the Side Channels
3
(92mm)
Cur
Hea
.
(Section 4)