Draper 83652 Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Draper 83652. Draper 83652 16 páginas. 135w 230v rotary multi-tool kit with flexible drive shaft
También para Draper 83652: Manual de instrucciones (16 páginas)

Imprimir página

BASIC MULTI-TOOL OPERATIONS

8.1

ACCESSORY INSTALLATION/

REPLACEMENT - FIG. 1

This Multi-Tool is designed for use with 2.0, 2.4 & 3.0mm

shank accessories only.

WARNING: Use bits of the correct shank diameter suitable

for the speed of the tool.

Selection of the correct accessory, suitable for the

intended application is vital. Seek guidance if uncertain of

selection.

Press the spindle lock button

nut

using the spanner

Choose from the collets provided, the appropriate size for

the accessory shank. If the size is not known insert the bit

into the collet. The collet which offers a machine fit to the

shank is the correct one to use. Do not force the bit into

the collet.

Place the collet into the spindle before loosely replacing

the collet nut

Slide the accessory in as far as possible before tightening

the collet nut. Press the spindle lock button

tighten the collet nut with the spanner provided to lock

the bit in place. If the accessory seems loose, reduce the

collet size to ensure the bit is secured correctly.

NOTE: Do not overtighten the collet nut

8.2

FITTING FLEXIBLE DRIVE SHAFT -

FIGS. 2 - 3

Remove collar

. Depress spindle lock button

remove the collet nut

loosely replace the collet nut.

Insert the flexible drive shaft rod

chuck and tighten. Screw the drive shaft collar

housing.

8.3

SWITCHING ON AND OFF - FIG. 4

Press switch

into the 'I' position. This will start the

machine. Press switch to the 'O' position - this will stop the

machine.

Using the variable speed dial

the speed of the collet chuck:

Position 1 - SLOW

Position 3 - MEDIUM

Position 6 - FAST

Select the correct speed for the work and type of bit you

are using.

and unscrew the collet

supplied.

. Install the 3.0mm collet and

into the collet

will enable you to alter

FIG.1

FIG.2

and

onto

FIG.3

FIG.4