Draper 83652 Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Draper 83652. Draper 83652 16 páginas. 135w 230v rotary multi-tool kit with flexible drive shaft
También para Draper 83652: Manual de instrucciones (16 páginas)

Imprimir página

BASIC MULTI-TOOL OPERATIONS

8.4

APPLICATIONS

Your multi-tool can be used for drilling, grinding,

polishing, milling and brushing. Other jobs like

engraving, cutting and removing rust are also possible. It

can be used on most wood, metal, glass and ceramics.

It is a good idea to practice on a scrap piece of material.

Best results are achieved by an even speed and pressure

(not too hard). Use lower speeds for larger tools and

higher speeds for smaller tools.

WARNING: Excessive force on this machine will cause

the motor to overheat and fail. This is not covered by

the guarantee.

8.5

HOLDING THE TOOL - FIGS. 5 - 6

For jobs such as milling or engraving where precision is

required, hold the multi-tool like a pen.

Care should be taken not to fully cover exhaust vents.

Covering the vents will cause the machine to overheat

and fail.

For heavier work like cutting or grinding hold the

multi-tool in the palm of your hand.

8.6

FITTING A CUTTING/SANDING DISC

- FIG. 7

With the disc holder

using the plain slot screwdriver

spanner handle tip). Leave one fibre washer on the

screw, place the cutting disc on the screw and fit the

second fibre washer, refit to the disc holder spindle.

(Do not over tighten).

8.7

FITTING THE SANDING DRUMS - FIG. 8

To fit a drum

, firstly loosen the small screw in the

top of the holder

relax. Slide the sanding drum onto the holder. To secure

simply tighten the screw and the rubber drum will swell,

gripping the drum. (Do not over tighten).

in the chuck, remove the screw

(incorporated in the

. This will allow the rubber to

FIG.5

FIG.6

FIG.7

FIG.8