Draper 57839 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Amoladora Draper 57839. Draper 57839 12 páginas.

Regular inspection and cleaning reduces the

necessity for maintenance operations and will keep

your tool in good working condition. The tool

bearings and gears are life-long lubricated, however

it is advised to check the condition of the grease in

the head every 100 hours, if necessary replace the

grease. The motor must be correctly ventilated during

tool operation. For this reason avoid blocking the air

inlets with hands. After use disconnect the tool from

the power supply and clean carefully, use compressed

air through ventilation slots.

DISPOSAL

At the end of the machine's working life, or when it

can no longer be repaired, ensure that it is disposed

of according to the standard regulations of the

country in which it is being used, and that the

disposal operation is carried out by specialized

personnel following authorized guidelines.

In all circumstances:

– Do not abandon in the environment;

– Do not dispose of together with solid urban waste

products;

– Contact the special recycling centres.

WARNING

Disconnect the plug from the power supply socket

before replacing any parts.

MAINTENANCE &

PART REPLACEMENT

BRUSHES

The brushes must be replaced after approx. 150-200

working hours, or if they are less then 5-6mm in

length.

WARNING

For correct tool operation always change the brushes

in pairs, not separately. The use of original Draper

spare parts is recommended. After having fitted new

brushes allow the motor to run for at least 5 minutes

without load for the brushes to bed.

IMPORTANT:

This operation should only be performed by an

authorized person.

REPLACING THE POWER SUPPLY CABLE

Check that the power supply cable is in good

condition, if not have it replaced by an authorized

person.

- 8 -