Bosch 800 Series Manual de instrucciones de instalación - Página 6

Figures 2, 3 and 4 contain many Drawer Microwave measure-

ments for reference when planning the drawer's location.

This Drawer Microwave can be installed below any electric or

gas wall oven.

NOTICE:

Always allow sufficient power cord length to the

Anti-Tip Block

Normal Installation Steps

Anti-Tip Block Installation Instructions

The anti-tip block reduces the risk of drawer tipping when

installed properly. Install the anti-tip block 14

above the installation opening floor (where the unit will

sit) for a standard installation or 14

installation. See Figure

3 (standard installation)

or Figure 4 (flush instal-

lation) and Figure 5.

The 6-inch anti-tip block

must be provided by the

installer.

If the Drawer Microwave

is ever moved to a

different location, the

anti-tip block must also

be moved and installed.

Flush Installation Dimensions and Clearances

Figure 4

inches

inches for a flush

Anti-Tip

block

Figure 5

electrical outlet to prevent tension.

Always check electrical codes for requirements.

If the anti-tip block is to be anchored to the wall make cer-

tain that the screws holding it penetrate into the structural

members (studs) behind any covering such as drywall.

The anti-tip block prevents serious injury that might result

from spilled hot liquids.

Make sure that the screws do not contact any

CAUTION

wiring or plumbing that may be present in the wall.

WARNING

The unit can tip and cause spills and potential burns

or other injuries if the anti-tip block is not installed

correctly.

English 6