Bosch 800 Series Manual de instalación - Página 7

Step 2 - Replace the orifices

WARNING

To prevent burns, do not touch grates, burner caps

or burners while hot. Turn the cooktop off and allow

the burners to cool.

Remove the grates and burner caps and burners.

Remove the orifices.

Notes

The orifices require a 7 mm socket driver for

▯

removal/replacement. The driver will need to be

inserted approximately 2

cavity to reach the orifice.

To reduce the chance of the orifice being dropped

▯

from the socket driver, add a piece of foam tape or

adhesive tape inside the socket.

Trim a small piece of the foam tape provided

with this kit (about

Fit this so the tape wraps against one side of

the socket so it stays in place.

The tape will fit to the orifice and help prevent

the orifice from falling out of the socket during

extraction.

Save the NG orifices in case there is need later to

restore the appliance to use natural gas again.

" (64 mm) into the burner

" x

" / 6 mm x 12 mm)

]

Identify the correct placement of the LP gas orifices as

detailed in the Before You Begin chapter.

Note: The NGMP056UC and NGMP656UC models

have a second orifice that will be visible after the

center burner is removed. This orifice must also be

changed during the conversion to use LP gas.

Smaller center orifice

The LP gas orifice sizes corresponding to each burner

are shown in the following images. These numbers are

engraved on either the top or the side of each orifice. It

is very important to install the correct orifice size for

each burner.