Bosch 800 Series Manual de instalación - Página 16

Imprimir página

WARNING

The rear vent trim has 3/16" (5 mm) standoffs to

keep the appliance slightly off of the back wall.

Do not remove or tamper with standoffs due to

potential temperature issues.

Check for proper installation and use of the anti-tip

10.

bracket. Carefully tip the range forward pulling from

the back to ensure that the anti-tip bracket engages

the range leg and prevents tip-over. The range should

not move more than 1" (2.5cm).

Connect Electrical Supply

WARNING

Before you plug in an electrical cord or turn on

power supply, make sure all controls are in the OFF

position.

Before connecting the 5 ft (1.5 m) supply cord to a wall

receptacle, make sure that the gas shut-off valve and all

burner controls are in the OFF position.

WARNING

ELECTRICAL GROUNDING INSTRUCTIONS

This appliance is equipped with a three-prong

grounding plug to protect you against the risk of

shocks and it should be plugged directly into a

properly grounded receptacle. Do not cut or remove

the grounding prong from this plug.

Burner Cap Placement

Sealed burners

Your new cooktop has sealed gas burners. There are no

burner parts under the cooktop to clean, disassemble or

adjust. Your cooktop has three different burner sizes:

small, large and dual-flame.

WARNING

To prevent flare-ups, do not use the cooktop without

all burner caps and all burner grates properly

positioned.

WARNING

To prevent burns, do not touch burner caps

orgrates while hot. Turn the cooktop off and allow

the burners to cool.

The burner parts must be correctly positioned for the

cooktop to function properly. If the burner parts are not

correctly positioned, one or more of the following

problems may occur:

Burner flames are too high.

▯

Flames shoot out of burners.

▯

Burners do not ignite.

▯

Burner flames light unevenly.

▯

Burner emits gas odor.

▯

Burner Cap and Burner Base Placement

After electrical connection is complete, place each

burner base on the corresponding location on the

cooktop. One of the three bars on the burner base

should line up with the notch and prevent the base from

rotating. The small hole or cutout near the edge should

also line up with the igniter. Pay special attention to avoid

damaging the igniter during installation of the base. See

Illustration below.

Once each base is located and resting evenly, place

each burner cap on its correct burner base. See

Illustration.

Place burner cap gently on top of base so that the

prongs of the burner base fit snugly into the groove of

the burner cap.

If the maintop is removed by a certified installer (for

example to check electrical or piping connection) the

panhead screws that were removed must be re-installed

to ensure proper functionality of burners.