Bosch FAP-OC 500Series Manual de servicio - Página 13

1. Press and hold Info for two seconds to access the Setup

menu.

2. Press the arrows

Temperature Offset.

3. Rotate the Settings dial to set the desired value.

4. Press the arrows

which will confirm the offset entry.

5. Press Info to exit the Setup menu.

Note: for double ovens, an offset can be entered separately for each

oven by selecting either Up. Offset or Lo. Offset from the menu.

4.6.1.3 HBL8x50

The oven must be Off in order to access the menu.

1. Press and hold Info for two seconds to access the Setup

menu.

2. Press the arrows

Temperature Offset.

3. Press + and – to set the desired value.

4. Press the arrows

which will confirm the offset entry.

5. Press Info to exit the Setup menu.

Note: for double ovens, an offset can be entered separately for each

oven by selecting either Up. Offset or Lo. Offset from the menu.

4.7

Broil Element

All Bosch models have a recessed 10-pass (240V 3600W) broil

element.

Refer to the Element Strip Diagram to test the element at the control

module, or

1. Remove the 2 T20 screws securing the element to the broil

reflector.

to advance through the menu to Oven

to advance to the next menu item,

to advance through the menu to Oven

to advance to the next menu item,

2. Remove the 2 T20 screws on either side of the element

terminals.

3. Pull the element toward you so that the terminal wires are

inside the oven cavity.

4. Disconnect the wires from the inner broil element terminals.

5. Use an ohmmeter to check for resistance of ~16 ohms.

4.8

Figure 12 reflects the variations of the B1, B2, and B3 user interfaces

used in the Bosch ovens.

Service Manual for Bosch Built-in Wall Ovens

Page 13 of 36