Bosch FAP-OC 500Series Panduan Servis - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Servis untuk Oven Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 36 halaman. Built-in wall ovens
Juga untuk Bosch FAP-OC 500Series: Panduan Petunjuk Instalasi (21 halaman), Petunjuk Penggunaan Manual (40 halaman), Panduan Instalasi (6 halaman), Informasi Produk (40 halaman), Panduan Instalasi (28 halaman), Panduan Pengguna (48 halaman), Panduan Pengguna (48 halaman), Panduan Instalasi (28 halaman), Panduan Penggunaan dan Perawatan (44 halaman), Panduan Instalasi (32 halaman), Panduan Penggunaan dan Perawatan / Petunjuk Pemasangan (40 halaman), Panduan Referensi Cepat (4 halaman), Panduan Penggunaan dan Perawatan (27 halaman), Panduan Instalasi (24 halaman), Panduan Instalasi (32 halaman), Panduan Penggunaan dan Perawatan (24 halaman), Panduan Instalasi (28 halaman), Panduan Servis (41 halaman), Panduan Penggunaan dan Perawatan (21 halaman), Panduan Instalasi (32 halaman), Panduan Instalasi (32 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Halaman Cetak
Bosch FAP-OC 500Series Panduan Servis
1. Press and hold Info for two seconds to access the Setup
menu.
2. Press the arrows
Temperature Offset.
3. Rotate the Settings dial to set the desired value.
4. Press the arrows
which will confirm the offset entry.
5. Press Info to exit the Setup menu.
Note: for double ovens, an offset can be entered separately for each
oven by selecting either Up. Offset or Lo. Offset from the menu.
4.6.1.3 HBL8x50
The oven must be Off in order to access the menu.
1. Press and hold Info for two seconds to access the Setup
menu.
2. Press the arrows
Temperature Offset.
3. Press + and – to set the desired value.
4. Press the arrows
which will confirm the offset entry.
5. Press Info to exit the Setup menu.
Note: for double ovens, an offset can be entered separately for each
oven by selecting either Up. Offset or Lo. Offset from the menu.
4.7

Broil Element

All Bosch models have a recessed 10-pass (240V 3600W) broil
element.
Refer to the Element Strip Diagram to test the element at the control
module, or
1. Remove the 2 T20 screws securing the element to the broil
reflector.
to advance through the menu to Oven
to advance to the next menu item,
to advance through the menu to Oven
to advance to the next menu item,
2. Remove the 2 T20 screws on either side of the element
terminals.
3. Pull the element toward you so that the terminal wires are
inside the oven cavity.
4. Disconnect the wires from the inner broil element terminals.
5. Use an ohmmeter to check for resistance of ~16 ohms.
4.8

User Interface

Figure 12 reflects the variations of the B1, B2, and B3 user interfaces
used in the Bosch ovens.
Service Manual for Bosch Built-in Wall Ovens
Page 13 of 36