Formax FD 280-10 Manual del usuario - Página 15
Navegue en línea o descargue pdf Manual del usuario para Plegadoras Formax FD 280-10. Formax FD 280-10 16 páginas.
Imprimir página6. TROUBLESHOOTING
6.1 Troubleshooting
Chart
Trouble
1. Feeder not running.
2. Product does not feed
properly.
Cause
POWER SWITCH is
off.
POWER CORD is not
plugged in.
No power in outlet.
LINE FUSE is blown.
Side guides do not fit
the product size,
causing skew.
Separators are not set
to correct product
thickness, causing
jams, curling, doubles,
skew etc.
Speed Control too fast,
pieces double and jam
on processing device
Solution
Turn POWER SWITCH
on.
Plug POWER CORD in.
Check circuit source for
blown fuse or circuit
breaker.
Contact authorized
Formax dealer.
Adjust side guides to
product size and fine
tune to produce good
feeding. (Section 5.1)
Adjust the product
separator. Be sure to
make consistent contact
across the piece. Set
each separator
separately.
Slow down feed speed.
Match speeds so that
the feeder is just a bit
slower than the next
device in line.