Formax FD 280-10 운영자 매뉴얼 - 페이지 15

{카테고리_이름} Formax FD 280-10에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Formax FD 280-10 16 페이지.

페이지 인쇄

6. TROUBLESHOOTING

6.1 Troubleshooting

Chart

Trouble

1. Feeder not running.

2. Product does not feed

properly.

Cause

POWER SWITCH is

off.

POWER CORD is not

plugged in.

No power in outlet.

LINE FUSE is blown.

Side guides do not fit

the product size,

causing skew.

Separators are not set

to correct product

thickness, causing

jams, curling, doubles,

skew etc.

Speed Control too fast,

pieces double and jam

on processing device

Solution

Turn POWER SWITCH

on.

Plug POWER CORD in.

Check circuit source for

blown fuse or circuit

breaker.

Contact authorized

Formax dealer.

Adjust side guides to

product size and fine

tune to produce good

feeding. (Section 5.1)

Adjust the product

separator. Be sure to

make consistent contact

across the piece. Set

each separator

separately.

Slow down feed speed.

Match speeds so that

the feeder is just a bit

slower than the next

device in line.