CommScope FACT Manual de instrucciones de instalación - Página 3

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Equipamiento industrial CommScope FACT. CommScope FACT 9 páginas. Fanout fixation kit
También para CommScope FACT: Instrucciones de instalación (8 páginas), Instrucciones de instalación (12 páginas), Instrucciones de instalación (8 páginas)

CommScope FACT Manual de instrucciones de instalación
5.

Cable preparation

5.1.

General cable preparation

5.1.1.
Mark the stripping point on the cable jacket. Make
sure that you have at least 2 meter of cable left.
5.1.2.
Cut the cable jacket at the marked point and
approx. 150 mm from the cable end to get access to the rip
cord.
5.1.3.
Use the rip cord to strip off the cable jacket.
5.1.4.
Separate the aramid yarns from the loose tubes.
Apply 2 pieces of foam.
5.2.
Cable preparation without central
strength member
5.2.1.
Fix the cable with 2 tie wraps. Route the aramid
yarns to the backside of the bracket.
5.2.2.
Make several turns around the strength member
connector to fix the aramid yarns, by using the allen key.
5.3.
Cable preparation with central
strength member
5.3.1.
Cut the strength member on length of+/- 55 mm.
© 2018 CommScope, Inc. All Rights Reserved
Page 3 of 9