ATI Technologies RCV Manual - Página 5

Navegue en línea o descargue pdf Manual para Equipamiento industrial ATI Technologies RCV. ATI Technologies RCV 6 páginas. Vane motor rebuild

Assembly
Fig. 26 Install rear end plate and
place bearing on rotor, using a small
socket or pipe that is the same
diameter as the inner race of the
bearing, tap bearing down until E-Clip
groove is visible.
Fig. 29 Install motor into motor
housing being sure to align pin
on rear and plate with hole in the
aluminum inlet housing.
Fig. 32 Install collet insert and collet
nut.
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •
Fig. 27 Install E-Clip using a small
screw driver. Motor should spin
freely, may need to tap rear of rotor
to achieve proper clearance of rear
end plate.
Fig. 30 Install motor clamp nut
Fig. 32 Assembly complete
5
Manual, RCV Vane Motor Rebuild
Document #9610-50-1033-02
Fig. 28 Install gasket onto rear end
plate.
Turn the Reverse Lever to top dead
center, or the twelve o'clock position
before removing Back Cap Bolts.
15
www.ati-ia.com