ATI Technologies RCV 매뉴얼 - 페이지 5

{카테고리_이름} ATI Technologies RCV에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Technologies RCV 6 페이지. Vane motor rebuild

Assembly

Fig. 26 Install rear end plate and

place bearing on rotor, using a small

socket or pipe that is the same

diameter as the inner race of the

bearing, tap bearing down until E-Clip

groove is visible.

Fig. 29 Install motor into motor

housing being sure to align pin

on rear and plate with hole in the

aluminum inlet housing.

Fig. 32 Install collet insert and collet

nut.

Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •

Fig. 27 Install E-Clip using a small

screw driver. Motor should spin

freely, may need to tap rear of rotor

to achieve proper clearance of rear

end plate.

Fig. 30 Install motor clamp nut

Fig. 32 Assembly complete

Manual, RCV Vane Motor Rebuild

Document #9610-50-1033-02

Fig. 28 Install gasket onto rear end

plate.

Turn the Reverse Lever to top dead

center, or the twelve o'clock position

before removing Back Cap Bolts.