ATI Technologies RCV 매뉴얼 - 페이지 3

{카테고리_이름} ATI Technologies RCV에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Technologies RCV 6 페이지. Vane motor rebuild

Disassembly

Fig. 10 Remove vanes from Rotor

Fig.13 Hold rotor in vise tightly

Fig. 16 Using a ½" wrench turn collet

body counter clockwise and remove

collet body from spindle.

Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •

Fig. 11 Slide spindle back from front

of housing and remove snap ring

from the inside, motor side of the

spindle housing.

Fig.14 Using a ½" wrench turn collet

body counter clockwise to remove

spindle from rotor. Remove snap ring,

spacer and Belleville washers, and

set aside.

Fig. 17 Take rotor to arbor press

and place rotor down with threads

pointing up and press rotor out of

bearing and front end plate.

Manual, RCV Vane Motor Rebuild

Document #9610-50-1033-02

Fig.12 Remove Spindle housing by

sliding out of the rear of housing.

Fig.15 Hold spindle in vise tightly

Fig, 18 Place spindle in arbor press

with threads pointing up being sure

to press against the inner race of the

bearing, press spindle out of bearing.