ATI Technologies RCV 매뉴얼 - 페이지 2

{카테고리_이름} ATI Technologies RCV에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Technologies RCV 6 페이지. Vane motor rebuild

Manual, RCV Vane Motor Rebuild

Document #9610-50-1033-02

Disassembly

Fig.1 Hold motor clamp nut in vise

snugly (do not over tighten, to avoid

crushing nut onto motor housing.)

Fig. 4 Remove motor from housing by

gently pulling straight out. (If it gets

stuck gently wiggle while pulling)

Fig. 7 Using a soft brass punch, hold

motor in your hand with the punch

lined up on the rear of the rotor and

gently tap off the rear end plate

bearing.

Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •

Use soft jaws for vise (Brass, Plastic,and Aluminum)

Fig. 2 Using a pin wrench loosen

motor housing by inserting pin into

one of the exhaust holes and turning

counter clockwise. (A band wrench

could also be used.)

Fig. 5-6 Remove E-Clip from rear

of rotor using a small screwdriver

or pick.

Fig. 8 Remove rear end plate.

Fig. 3 Remove motor clamp nut

Fig. 6

Fig. 9 Remove cylinder