Bosch 6 Series Manual de instrucciones de instalación y uso - Página 17

5Installation

P reparing for installation

I n s t a l l a t i o n

Caution!

Ensure that there are no electrical wires, gas pipes or

water pipes in the area where holes are to be drilled.

If the extractor hood is to be operated in exhaust-air

mode, a flue duct must be fitted.

If the extractor hood is to be operated in air-recirculation

mode, an optional accessory must be fitted. To do this,

refer to the installation instructions provided. The flue

duct does not need to be fitted for air-recirculation

mode.

Determine where the extractor hood should be

positioned and lightly mark where the lower edge of

the appliance should be on the wall. Determine

where the middle should be based on the hob.

We recommend fitting the extractor hood such

Note:

that the lower edge of the glass screen is in line with

the lower edges of the adjacent wall-hung cabinets.

Make sure that the specified safety clearances from

the hob are complied with.

Place the template against the line drawn on the wall

and fasten it in place. Mark where the screws should

be inserted.

To fit the flue duct, the template must be cut along

the marked cut line.

Drill 8 mm diameter holes to a depth of 80 mm for

fastening the appliance, remove the template and

press in the wall plugs flush with the wall.

Installation en