CAROL DW-26 Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Sistema de micrófono CAROL DW-26. CAROL DW-26 10 páginas. 2.4g digital wireless microphone system

Imprimir página
5
5
Mixer Switch：Can switch between SEPARATE and MIX modes. In SEPA-
RATE mode, Transmitter 1 and Transmitter 2 are output through audio
port 1 and audio port 2 respectively. In MIX mode, Transmitter 1 and
Transmitter 2 are mixed then output through audio port 1.
6
Transmitter 1 Output Switch：1 Output Switch: Can switch between
MIC OUT
and LINE OUT
mode (lower output volume) when using a microphone, and LINE OUT
mode (higher output volume) for musical instruments.
7
Transmitter 2 Output Switch: As above.
8
Micro USB Power Port:Can be connected to
power banks or a power supply with DC 5V/1A
USB output via the included USB cable.
9
Transmitter 1 Audio Por t:Connect to the
8
amplifier system via a ø6.3 cable. The audio
signal from Transmitter 1 is output from here.
9
If mixer mode is set to"MIX" then the audio
signals from Transmitter 1 and 2 will both be
output here.
10
Transmitter 2 Audio Por t:Connect to the
10
amplifier system via a ø6.3 cable. The audio signal
from Transmitter 2 is output from here.
8
6
7
modes. We recommend using the MIC OUT
DW-26 Digital Wireless Transmitter (as shown in Figure 3.2)
1
2
3
5
( Figure 3.2 )
1
Adapter: DW-26 offers three different connection types (optional)
1.DW-26C:ø 3.5mm female connector suitable for condenser microphones.
2.DW-26D:XLR female connector suitable for dynamic microphones.
3.DW-26I: ø 6.3mm male connector suitable for connecting with musical instruments.
2
Status LED:Light is green when the device is on and battery level is good;
when battery is low and needs to be replaced the status LED is red; during
pairing the light blinks green.
3
Power Button:Hold down for 2 second to turn on. The power light also
comes on. Hold down for 3 seconds to switch off. The power light will also
go off.
4
Battery Cover:Used to protect the battery. The battery is also replaced
from here.
5
Volume Button: Volume Button: Use to increase or reduce the output
volume.
6
Transmitter Reset Button: Used for renewing receiver pairing.
(FOR TECHNICIAN USE ONLY)
7
Battery Compartment:Accommodates two AAA batteries.
6
4
7
9