Airtec CYPRES Manual de instrucciones - Página 16

Navegue en línea o descargue pdf Manual de instrucciones para Instrumentos de medida Airtec CYPRES. Airtec CYPRES 17 páginas. Water resistant kit

Instruction Manual CYPRES Water Resistant Kit
Replacement of the field replaceable cutter
• Make sure the CYPRES is switched off
• Use a sharp knife to cut the silicone along the line between the grey
and the black part of the plug.
• You should then unplug the old cutter and replace it by a new one.
(See CYPRES user's guide chapter 6.3.)
• In order to make the plug waterproof you should use the silicone
provided in your Water Resistant Kit and cover the grey end of the
plug as well as approximately 1 cm of the cable.
• Make sure, that the silicone already on the black side of the plug and
the new part on the grey side form an integrated whole. This might
easily be achieved by overlapping the silicone slightly and then
smoothing it with your fingertips.
• You should then use one of the cable ties also provided in your Water
Resistant Kit and place it around the cable on the grey side, pull it
tight and cut off the surplus. (This can also be seen on the black side
of your plug.)
• Allow it to dry for 24 hours before installing it into the rig.
Airtec GmbH
page 16