Airtec CYPRES Manuel d'instruction - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Airtec CYPRES. Airtec CYPRES 17 pages. Water resistant kit

Instruction Manual CYPRES Water Resistant Kit

Replacement of the field replaceable cutter

• Make sure the CYPRES is switched off

• Use a sharp knife to cut the silicone along the line between the grey

and the black part of the plug.

• You should then unplug the old cutter and replace it by a new one.

(See CYPRES user's guide chapter 6.3.)

• In order to make the plug waterproof you should use the silicone

provided in your Water Resistant Kit and cover the grey end of the

plug as well as approximately 1 cm of the cable.

• Make sure, that the silicone already on the black side of the plug and

the new part on the grey side form an integrated whole. This might

easily be achieved by overlapping the silicone slightly and then

smoothing it with your fingertips.

• You should then use one of the cable ties also provided in your Water

Resistant Kit and place it around the cable on the grey side, pull it

tight and cut off the surplus. (This can also be seen on the black side

of your plug.)

• Allow it to dry for 24 hours before installing it into the rig.

Airtec GmbH

page 16