Andis TC-2 Manual de instrucciones de uso y mantenimiento - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Cortapelos Andis TC-2. Andis TC-2 20 páginas.

CARE AND SERVICING OF YOUR ANDIS CLIPPER/TRIMMER

BLADES

Blades should be oiled before, during, and after each use. If your clipper/trimmer

blades leave streaks or slows down, it's a sure sign blades need oil. The clipper/

trimmer should be held in position shown in Figure C to prevent oil from getting

into motor. Place a few drops of Andis Clipper Oil on the front and side of the cutter

blades (Figure D). Wipe excess oil off blades with a soft, dry cloth. Spray lubricants

contain insufficient oil for good lubrication, but are an excellent clipper/trimmer

coolant. Always replace broken or nicked blades to prevent injury. You can clean the

excess hair from your blades by using a small brush or worn out tooth brush. To clean

the blades we suggest to immerse the blades only into a shallow pan of Andis Blade

Care Plus, while the clipper/trimmer is running. Any excess hair and dirt that has

accumulated between the blades should come out. After cleaning, turn your clipper/

trimmer off and dry blades with a soft, dry cloth and start clipping again.

REMOVAL OF BLADE SET

To remove the blades, first unplug the clipper/trimmer from the electrical outlet.

Hold the clipper/trimmer so that the blade teeth are pointing up. Press forward on

blade (Figure E).

REPLACEMENT OF BLADE SET

Align blade yoke armature pin in correct position before replacement of blade set

(Figure G). To replace the blade, line up the bottom hook of blade set with the slot on

the clipper/trimmer and snap into place (Figures F & G).

CLIPPER/TRIMMER REPAIR SERVICE

When the blades of your Andis clipper/trimmer become dull after repeated use, it

is advised to purchase a new set of blades available through your Andis supplier or

through an Andis authorized service station. If you wish your clipper/trimmer to be

serviced as well, it should be carefully packed and mailed either parcel post insured,

or U.P.S. to any Andis authorized service station.

CAUTION: Never handle your Andis clipper/trimmer while you are operating a

water faucet, and never hold your clipper under a water faucet or in water. There is

danger of electrical shock and damage to your clipper. Andis Company will not

be responsible in case of injury due to this carelessness.