Electrolux EHC944BB Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Placa Electrolux EHC944BB. Electrolux EHC944BB 20 páginas. Ceramic glass hob

Imprimir página

TROUBLESHOOTING

Problem

Red rings, limescale or water

rings, shiny metallic or other

discolouration, scratches/

shadows, bubbles or other

miscellaneous marks or stains on

ceramic glass cooktop surface.

Pitting of ceramic glass surface.

The cooking zones will not switch

on or are not functioning.

Acoustic signal sounds when

appliance is switched off.

The residual heat indicator is not

displaying anything.

The automatic warm up function is

not switching itself on.

Acoustic signal sounds and

appliance switches itself on and

then off again; after 5 seconds

another acoustic signal sounds.

is lit.

and number are displayed.

If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the

Customer Care Department.

WARNING!

Repairs to the appliance are only to be carried out

by qualified service engineers. Considerable danger

to the user may result from improper repairs.

Possible cause

Cooktop surface has not been

cleaned correctly. Cleaning of the

cooktop surface is not covered under

warranty. If a service call is placed

to clean the cooktop you will be

charged for the visit.

Spillovers of liquid with high sugar

content.

• More than 10 seconds have

passed since the appliance was

switched on.

• The child safety device is switched

• Several sensor fields were touched

at the same time.

• Automatic switch off has been

triggered.

• The lock is switched on

The control panel is wholly or partly

covered by objects.

The cooking zone was only on for a

short time and is therefore not hot.

• There is still residual heat on the

cooking zone

• The highest heat setting is set

• The heat setting was set using the

sensor field .

The On/Off sensor field has been

covered up, e.g. by a cloth.

• Overheating protection for the

cooking zone has been triggered.

• Automatic switch off has been

triggered.

Electronics fault.

Remedy

Use a ceramic glass cleaner such as

Cerapol.

These types of spills must be removed

immediately with a special scraper for

the glass. If not permanent damage to

the cooktop glass can occur which is not

covered under warranty.

Switch the appliance on again.

Deactivate the child safety device (See the

section "Child safety device").

Only touch one sensor field.

Remove any objects (pan, cloths, etc.) that

are lying on the control panel. Switch the

appliance on again.

Switch off the lock (See the section

"Locking/unlocking the control panel").

Remove objects.

If the cooking zone is supposed to be hot,

call the Customer Service Department.

Let the cooking zone cool down.

The highest heat setting has the same

power as the automatic warm up function.

1. Switch off the cooking zone

2. Set the cooking zone using the sensor

field

Do not place any objects on the control

panel.

Switch off the cooking zone. Switch the

cooking zone on again.

Switch off the cooking zone. Switch the

cooking zone on again.

Disconnect the appliance from the electrical

supply for a few minutes (Take the fuse

out of the house's wiring system) If after

switching on again,

call the customer service department.

IMPORTANT!

If the appliance has been wrongly operated, the visit from

the customer service technician or dealer may not take

place free of charge, even during the warranty period.

is displayed again,