Dremel DigiLab 3D45 Manual de inicio rápido - Página 2
Navegue en línea o descargue pdf Manual de inicio rápido para Impresoras 3D Dremel DigiLab 3D45. Dremel DigiLab 3D45 2 páginas. Print removal
También para Dremel DigiLab 3D45: Manual de inicio rápido (2 páginas), Instrucciones de servicio (4 páginas), Manual de instrucciones (2 páginas), Manual (4 páginas), Manual de servicio (4 páginas), Manual de calibración (2 páginas)
Imprimir página
Step 2: Remove build plate from printer
a. Remove the build plate from the printer using the tabs on
right and left side of build plate (shown in picture 1). Place
it vertically against a sturdy surface (shown in picture 2).
1.
2.
b. Ensure the build plate is well secure and will not slip once
object removal tool is being used.
2610038113
All manuals and user guides at all-guides.com
Step 3: Remove the printed part
a. Place the tip of the object removal tool where the print is
b. Give a firm bump on the top part of the object removal tool
c. Repeat this process if needed until the part detaches from
Congratulations!
You are now ready to build. Build On.
attached to the build plate (shown in the figure below).
(see red arrow).
the build plate.
08/2018