Dremel DigiLab 3D45 Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Printer 3D Dremel DigiLab 3D45. Dremel DigiLab 3D45 2 halaman. Print removal
Juga untuk Dremel DigiLab 3D45: Panduan Memulai Cepat (2 halaman), Petunjuk Servis (4 halaman), Buku Petunjuk (2 halaman), Manual (4 halaman), Panduan Servis (4 halaman), Panduan Kalibrasi (2 halaman)

Step 2: Remove build plate from printer

a. Remove the build plate from the printer using the tabs on

right and left side of build plate (shown in picture 1). Place

it vertically against a sturdy surface (shown in picture 2).

b. Ensure the build plate is well secure and will not slip once

object removal tool is being used.

2610038113

All manuals and user guides at all-guides.com

Step 3: Remove the printed part

a. Place the tip of the object removal tool where the print is

b. Give a firm bump on the top part of the object removal tool

c. Repeat this process if needed until the part detaches from

Congratulations!

You are now ready to build. Build On.

attached to the build plate (shown in the figure below).

(see red arrow).

the build plate.

08/2018