Atlantic Ultraviolet MIN-6 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Sistemas de filtración de agua Atlantic Ultraviolet MIN-6. Atlantic Ultraviolet MIN-6 16 páginas. Germicidal ultraviolet water purifiers
También para Atlantic Ultraviolet MIN-6: Manual del usuario (16 páginas), Manual del usuario (20 páginas)

Imprimir página

TROUBLESHOOTING

Always disconnect power to the water purifier before performing any service or maintenance.

IMPORTANT: This unit is to be serviced ONLY by qualified, and appropriately licensed, personnel.

Problem

Purifier not operating

Water leaking from purifier

Poor purifier

disinfection performance

Ballast No. 10-0508B and 10-0504B have Lamp-Out Protection

If power is applied to the ballast without a lamp connected to the circuit or if the lamp fails, the ballast's lamp-out protection

will prevent the ballast from operating, and a red LED light will illuminate and audio alarm will sound. To reset: disconnect the

ballast from power and reconnect or replace the lamp. The ballast must remain disconnected from power for (2) minutes to

reset. After 2 minutes restore input power, ballast should resume proper operation.

The equipment that this ballast is used with requires connection to a known good ground. It is the User's

responsibility to ensure that their equipment is properly grounded in compliance with the National Electrical Code and any

applicable local codes. Equipment wiring and hook up should be performed by a qualified, licensed electrician. Failure to comply

with this requirement could result in serious injury or death.

Table 3 – Troubleshooting

Possible Cause

No electrical power

Cracked or broken quartz sleeve

Quartz sleeve sealing O-Ring(s)

worn, damaged

Poor, or loose, connections

or fittings

Quartz sleeve fouled

Germicidal Lamp

STER-L-RAY

output depreciating

STER-L-RAY

Germicidal Lamp

not functioning

Low input voltage

Change in water quality

Corrective Action

Verify that the purifier is connected to a live

power source.

Shut down purifier, drain, and replace quartz sleeve.

See "Replacement of Broken Quartz Sleeve" in the

"Maintenance" section.

Shut down purifier, drain, and remove static gland

nut, replace sealing O-Ring. See "Quartz Sleeve

Installation, Cleaning, or Replacement" in the

"Maintenance" section.

Tighten suspect connection or fitting; or shut down

purifier, drain, and remove fitting or connection. Clean

threads; reapply thread sealing tape and reinstall.

Clean quartz sleeve, see "Quartz Sleeve Installation,

Cleaning, or Replacement" Section.

Replace lamp, as it nears its end of life (EOL).

See "Lamp Installation or Replacement" in the

"Maintenance" section.

Replace lamp. See "Lamp Installation or

Replacement" in the "Maintenance" section.

Verify input voltage to purifier.

Have water tested to confirm that it does not exceed

maximum recommended concentration levels for use

with this purifier.