Bosch 2 Manual de instalación y uso - Página 16

Imprimir página

1. Putting into Operation

BTEXACT_bu_3609929A44_t.fm Seite 15 Montag, 5. September 2005 2:12 14

close the LED work area lamp 26 can now be placed

in any desired position. Take care not to damage the

cable of the LED work area lamp and slide it into the

cavity 31 intended for it in the housing shell without

6 MAINTENANCE AND SERVICE

Maintenance

Remove the battery from the power tool before

adjustments are made to the tool, accessories

are changed or the tool is stored. This safety

measure prevents the unintentional switching on of

the power tool.

Should the tool fail in spite of careful manufacturing

and testing procedures, have the repairs performed

by an authorized customer service center for Bosch

power tools.

For inquiries and spare parts ordering, please include

the 10-place article number on the nameplate of the

tool.

After approx. 150 hours of operation, the gearbox is

to be cleaned for the first time and then after every

300 hours of operation. After each cleaning, it should

be lubricated with special gearbox grease.

The moving parts of the coupling are to be lubricated

every approx. 100000 screwing fasteners with a few

drops of SAE 10/SAE 20 motor oil. The sliding and

rolling parts are to be lubricated with Molycote

grease. Check the setting of the coupling after lubri-

cating.

Lubrication

Lubricant:

Special gearbox grease 225 ml

3 605 430 009

Molycote grease

SAE 10/SAE 20 motor oil

Have maintenance and repair work performed

only by qualified specialists. In this manner, it can

be ensured that the safety of the tool is maintained.

Any Bosch customer service center can perform this

work quickly and reliably.

Dispose of lubricants and cleaning agents in an

environment-friendly manner. Comply with the

legal regulations.

3 609 929 A44 • (05.09) T

kinking. Enclose the LED work area lamp 26 again

with the two housing shells of the LED holder 15.

Press the spring ring 30 and the marking ring 19 back

to their initial positions.

Accessories

You can obtain NiCd battery packs and voltage

adapters for voltages of 9.6 V, 12.0 V, and 14.4 V,

Screw heads, constant voltage regulator 4EXACT,

and access point EXAConnecT at your specialty

dealer.

Bosch offers various charging units for the batter-

ies:

AL 15 FC 2498

ML 60-4

For the selection of the suitable charger, assistance

is provided by the authorized Bosch customer serv-

ice center for power tools or your dealer.

Information about the complete quality accessory

program can be found on the Internet at

www.bosch-pt.com and

www.boschproductiontools.com or at your dealer.

Service

Robert Bosch GmbH is responsible for the delivery of

the tool in accordance with the sales contract within

the framework of the legal/country-specific regula-

tions. For claims with respect to the tool, please con-

tact the following location:

Fax . . . . . . . . . . . . . . . . . . . . +49 (711) 7 58 24 36

www.boschproductiontools.com

English–15