Electrolux # Manual de uso y mantenimiento - Página 15

Imprimir página

Electrolux # Manual de uso y mantenimiento

CLEANING THE BURNER GRATES, BURNER CAPS AND

BURNER HEADS

The Grates, Burner Caps and the Large 18k Burner Head should be routinely cleaned.

Keeping the burner ports clean will prevent improper ignition and an uneven flame. If

needed, the fixed burners should be cleaned in place with an humid cloth (do not spraw

water on them).

Refer to the following instructions:

To Remove and Replace the Surface Burner Grate, Surface

Burner Cap and Surface Burner Head - Remove in the

following order; (1st) Surface Burner Grate, (2nd) Surface

Burner Cap, (3rd) Surface Burner Head (See Figure 1).

Reverse the procedure above to replace the Surface Burner

Cap, Surface Burner Head and Surface Burner Grate. Do

not remove any burner parts from the cooktop until the

burner parts have completely cooled and are safe to

handle. Do not operate the surface burners without the

Surface Burner Heads, Surface Burner Caps and

Surface Burner Grates properly in place.

To Clean the Burner Caps, Burner Heads and Burner Grates -

Use a soap-filled scouring pad or a mild abrasive cleaner to clean

the surface burner caps and surface burner heads. The Grates

are designed to be Dishwasher safe for cleaning. The ports (or

slots) around the burner heads must be routinely cleaned. If

residue still remains in these ports, use a small-gauge wire or needle to clean the slots

or holes being careful not to damage the electrode. For proper flow of gas and ignition of

the burner—DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER

MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS make sure

that the surface burner cap, the surface burner head and the surface burner grate are

properly in place whenever a surface burner is in use.

Surface Burner

Grate

THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.

CAUTION

UTION

- Use caution when replacing the burner head so the electrode is not damaged. A damaged

electrode may cause a delayed ignition or prevent the burner from igniting

- Any additions, changes or conversions required in order for this appliance to perform

satisfactorily must be made by a qualified service technician.

General Care & Cleaning

Surface Burner

Caps

1st

2nd

3rd

Orifice

Electrode

Surface Burner

Head

Surface Burner

Grate

Surface

Burner

Cap

Surface

Burner

Head

Figure 1