Electrolux # Manual del usuario - Página 8

Imprimir página

Troubleshooting

For your safety, turn vacuum cleaner off and unplug power cord before attempting to resolve problems.

Problem

Motor will not start or

suddenly stops

No suction; vacuum cleaner does

not pick up lint or dirt.

Dust cup will not lock

Quick Release handle will not

lock into vacuum cleaner.

Brush roll will not turn.

Red 'check brush roll' or 'check

filter' indicator light is on.

Possible cause

Solution

Unit not connected to

power source.

Switch not turned on.

Thermal cut-off

has operated.

Blockage in hose.

Dust cup full.

Foam filter clogged.

Filter screen clogged

Foam filter not

in place.

Switch not on

proper setting.

Turbo nozzle clogged

Filter screen not in place.

Dusting brush and

telescopic wand are

extended.

Object caught in

brush roll.

Belt and/or brush roll not

positioned properly.

Brush roll not operating

properly or foam filter

is clogged.

Push plug securely into outlet.

Try another outlet and check circuit breaker.

Check plug and cord for damage.

Press power switch to 'carpet' or 'hard floor setting.

Correct the cause of motor overheating. See thermal

cut-off information page 1.

Remove any obstructions that restrict airflow through

hose. See page 5.

Empty dust cup. Make sure both chambers are

empty. See page 4.

Remove and clean foam filter. See page 4.

Fine dust can block airflow through the foam filter

and reduce suction, even if dust cup does not look

Remove and clean filter screen. See page 4.

Make sure filter screen stays in place inside dust cup

at all times.

Foam filter must be in filter frame for correct

performance. See page 4.

Make sure filter frame is installed properly in filter

cover for dust cup assembly to fit back into place.

See page 4.

Use 'carpet' setting for carpeted floors.

Use 'hard floor' setting for hard-surface floors and

when using accessories.

Remove and clean debris from turbo nozzle.

Locate filter screen and insert into dust cup.

See page 4.

Retract telescopic wand and dusting brush to expose

end of wand. See page 3.

Place end of wand into opening on back of vacuum

and align ribs into grooves. See page 2.

Remove the obstruction (such as carpet fringe,

string or sock). Note: brush roll overload protector will

reset when vacuum is turned off or unplugged.

Use 'hard floor' setting when vacuuming fringe

of rugs.

Check brush roll for threads and debris; clean if

needed. See page 5.

Make sure belt is on motor pulley and fitted into

grooves on brush roll. See page 5.

Make sure both ends of brush roll are free of debris

and secured properly so roll can rotate freely. See

page 5.

Check brush roll for threads and debris; clean if

needed. See page 5.