Bose 301 Series V Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Altavoces Bose 301 Series V. Bose 301 Series V 10 páginas. Direct/reflecting speakers
También para Bose 301 Series V: Manual del usuario (13 páginas), Manual del usuario (12 páginas), Manual del usuario (12 páginas), Manual del usuario (21 páginas), Manual del usuario (13 páginas), Manual del usuario (16 páginas)

Imprimir página

DISASSEMBLY/ASSEMBLY PROCEDURES

Note: Refer to figure 3 for the following

procedures.

1. Grille Removal

1.1 Grasp the top and bottom edges of the

grille (12) and pull off the grille.

2. Grille Replacement

2.1 Align the grille (12) so that the Bose

logo (11) is right side up on the tweeter

side of the cabinet and push it into place.

3. Woofer Removal

3.1 Perform procedure 1.

3.2 Remove the four screws (13) that

secure the woofer (14) to the cabinet.

3.3 Lift the woofer out and cut the wires as

close to the terminals as possible.

4. Woofer Replacement

4.1 Strip the wires and connect the wires as

shown in figure 1. The red wire to the single

center terminal. The black wire to the right

side double terminal (looking at the woofer

magnet side down). The orange and green

wires to the left double terminal. The

capacitor is connected to the far left and

right terminals.

4.2 Secure the woofer (14) to the cabinet

using four screws (13).

4.3 Perform procedure 2.

5. Front Tweeter Removal

5.1 Perform procedures 1, 3.2 and lift the

wooter out of the cabinet, but do not cut the

wires.

5.2 Using a 1/4 inch socket, remove the

screw (6) and bracket (7) that secures the

tweeter (8) to the cabinet.

5.3 Lift the tweeter out of the cabinet and

cut the wires as close to the terminals as

possible.

6. Front Tweeter Replacement

6.1 Strip the wires and connect the red

wire to the positive (+) terminal and the

black wire to the negative (-) terminal.

Dress or twist the wires to prevent buzzes.

6.2 Place the tweeter (8) into the cabinet

and secure it using the tweeter bracket (7)

and screw (6).

6.3 Perform procedures 4.2 and 2.

7. Rear Tweeter Removal

7.1 Perform procedures 1, 3.2 and lift the

woofer out of the cabinet, but do not cut the

wires.

7.2 Using a 1/4 inch wrench, remove the

screw (1) and bracket (2) that secures the

tweeter (3) to the cabinet.

7.3 Lift the tweeter out of the cabinet and

cut the wires as close to the terminals as

possible.

orange

green

Figure 1. Woofer Wiring Configuration

red

black