3M G5 Manual - Página 3

Navegue en línea o descargue pdf Manual para Auriculares 3M G5. 3M G5 10 páginas. Drive-thru systems
También para 3M G5: Manual de consulta rápida (2 páginas), Boletín técnico (6 páginas), Boletín técnico (2 páginas), Manual de inicio rápido (3 páginas), Boletín técnico (12 páginas), Manual (8 páginas)

1. Disconnect and Remove the XT-1 Basestation off the wall

To remove the base station cover:

Disconnect power from the base station.

Loosen the two screws located at the bottom of the cover.

Lift the cover upward and away. The display and keypad remain with the base, not with the cover.

Disconnect wires terminating on XT-1 basestation

Disconnect one wires, one at a time, from the phoenix connectors on the XT-1 basestation.

- Make sure you label each wire so you know what terminal they connect to.

For example: MEN SKR +, or MEN SKR -, or GND or MIC+ or MIC- etc

This should not be required if you have employed 3Ms guidelines on properly terminating color coded cables to

terminals on the XT-1 Basestation.

Blue & White -> Order Point Speaker

Red & Black +Shield -> Order Point Microphone + GND

Green & Yellow -> Loop terminals on Vehicle Detector board (If using Internal Vehicle Detector)

Disconnect any Range Extenders

Disconnect one any Omni-Directional or Patch antennas connected to the XT-1 Basestation

Disconnect any external Momentary Closed Switches they may have installed to change Order Taking Modes,

SPLIT/CROSS, or DAY/NIGHT

Most often these external switches are labeled (on the wall). It is important that while re-wiring, the same functionality (relative

to each switch) is maintained.

Remove the XT-1 basestation off the wall

Detach the XT-1 basestation off the wall by removing the 4 screws.

Set XT-1 basestation aside.

Screws